The pinion gear is attached to the fly wheel and spins the big gear which turns the main drive shaft that presses the tablets. Overtime, the teeth on the pinion gear will break off and cause the big gear to not spin correctly. Replacing the pinion gear
The Top Rush Rod Cam hold the Top Rush Rod in place on the Drive Shaft. By rotating off center this causes the Top Rush Rod, which holds the top Die, to ride up and down.
Eccenter for TDP-5
The Lift Pole lifts the finished tablet out of the Ring Die Mold.
The bucket feeder holds the tablet powder and has two primary functions.
It fills the ring die before the tablet is pressed and pushes the finished tablet out of the way while filling the ring die for the next tablet.
Tablet Press Punch blank midline bevel edge round Die 10mm for TDP-5
Pill press mold blank midline shaped Die 20*10MM For TDP-5
Pill press mold blank midline Oval Shallow arc shaped Die 20*10MM For TDP-5
Pill press mold blank midline shaped Die 15*7MM For TDP-5
Pill press mold blank midline Oval Shallow arc shaped Die 15*7MM For TDP-5